Friday, April 12, 2013

Simple Remote Doorbell Warning Switch Circuit

This circuit should only be used with the solenoid type chime doorbells, the electronic type that play tunes will not work here. This is the simple circuit design.


The basic principle work is the hardest part for this circuit was the title. It is quite easy to miss the sound of a doorbell if you are watching the television, this circuit gets round the problem by providing a visual indication, i.e. a lamp. As an alternative, a LED could also be used. You could just parallel a lamp across the doorbell, but this would mean extra drain from the doorbell batteries or transformer.

Using a series resistor R1 actually reduces current flow, and if run from batteries, will give them a longer life. The value of R1 is chosen so that about 0.6 to 0.7 volts is dropped across it, and the doorbell should still ring. I used a combination of a 22 ohm resistor in parallel with a 50 ohm. The doorbell still rang and circuit operated correctly. I used to have an electromechanical counter that registered each time when someone pressed the switch.
 
Copyright © 2012. Raul's Diagrams Collection - Posts · Comments
Powered by Blogger